| Products |
| News |
| waiter Dryer FD-2017/FD-2117 |
 |
The Features of the Products: Hand Dryer of Model FD-2017, FD-2117 are powerful , low noise, strong wind, safe, features reliable, and is easy to operate. It is really good equipment in toilet for Hotels, Restaurants, Office Buildings, Shopping Centers, Healthy Centers, Saunas, Airports, Stations, etc. for preventing cross infections and to keep personal hygiene. |
| The Main Tech Data |
|
| Fixing Measurements:(mm) |
 |
| Functions and Features |
| 1. FD-2017: It is of automatic type with infra-red sensing switch, it activates fast, convenient in operation and is of hygiene. Sensor range adjustable: Open the metal cover of the machine, turn the adjustor on the control IC. Turning it clockwise, the sensor range extending and counter- clockwise shortening (for specialist only). 2. FD-2117: It is of manual type with a button switch, at each pressing, the Hand Dryer will run 30 seconds. It is reliable and shall not be easily interfered. It has dual protective devices: recoverable temperature controller and the fuse. 3. Red LED lit means the machine is at standby and the green LED lit running. 4. The hand dryer of Model FD-2017/FD-2117 are designed according to dimensionless parameter and to air dynamics, takes in air through both directions; Thus it generates strong wind with low noise. |
| Installation: |
| Please check the voltage of the unit is set correctly as with the local voltage. And do cut off the power before maintenance or repair. 1. Hand dryer should be installed by specialist following the local governments regulations to guarantee the machine work normally. As to installation height, please refer to our suggestion (see attached scheme of the safe place for installation). 2. The hand dryer is sold with a mounting diagram. First, take down the fixed screws on both sides, dismount the cover, then drill 4 holes of Φ8mm at the positions marked on the mounting diagram, put the expansible bolts or equivalent then fixing the board with screws onto the wall. Lead out the wire on either side of the unit according to the situation, and then mount the cover at last. Attention: Do not test the motor before finishing the installation of the unit, otherwise it is easy to cause un-predicable result. |
| Fig. of Installation |
|
| Circuit Diagram: (attached) |
|
| Usage: |
| 1. FD-2017:When your hands are present, dryer automatically activates, and it shut off when hands are removed. 2. FD-2117:Dryer shall be activated as the button pressed, and stops automatically in 30 seconds and returns to standby. |
| Maintenance and points for attention: |
| 1. Do not install the hand dryer in environments of corrosive air and conductive dusts. In general, hand dryer does not need special maintenance; it can work normally many years provided you follow the instructions mentioned above. 2. Do not chip and damage the surface; when the dryer is dirty, do not scrub with chemical solvent, but neutral detergent is OK, then clean it with clear wet fabric. Attention: Do cut off the power when cleaning, and prevent splashing water into the machine to cause power leakage and damage the Machine. |
| Frequently appear troubles and their solutions |
1. If the troubles still exist after following all the steps mentioned above,please contact the local maintenance people or professional person. |
